And, if a mint flavoring can sting the eyes if a little is left in the edges, imagine a cleanser – that could really be problematic. They have several chemicals that may be harsh on the silicone skirt and harsh on the skin. SoftScrub® claims it is safe to use on glass but I am not a fan of abrasive cleansers for treating a mask. This may be true, but a very thorough rinsing after each application should be fine.Ī note on SoftScrub®: Also, many instructors say to use an abrasive cleanser like SoftScrub® to remove the film. Watch the very detailed and very informational two-part video series:Ī couple items for you to note: Some instructors say not to use mint toothpaste as it will sting the eyes. Repeat these steps, drying the lens in between each application, 5 to 7 times. ![]() Once the toothpaste is rinsed away, DRY the lens with a clean towel or rag.ĥ. Note that toothpaste may accumulate in the edges, so use a little more water pressure if needed to remove it, or you may use a soft, wet washcloth.Ĥ. Rinse the lens while rubbing away the toothpaste. Give it a good circular rubbing with your CLEAN fingers.ģ. Take a thimble-sized amount of toothpaste and rub it on both sides of the DRY lenses. One way to minimize scratching plastic (polycarbonate) lenses is to use a soft, wet washcloth and rub lightly in a circular motion.Ģ. Toothpaste, or other abrasive agents, as well as fingernails may scratch and ruin plastic lenses! If you decide to pre-treat your plastic (polycarbonate) lens with toothpaste, do so at your own risk. Plastic lens masks, such as the freediving favorite AquaSphere Sphera mask, scratch easily and may even come with an anti-fog agent already applied to the lens. NOTE: THIS IS FOR GLASS LENSES ONLY, NOT PLASTIC (POLYCARBONATE) LENSES. Avoid gel type toothpaste and go for common white toothpaste. ![]() To remove the film, use a slightly abrasive agent like toothpaste. The solution is to “pre-treat” or “prep” the mask by removing this film prior to its use.ġ. This silicone is resistant to any of the conventional de-fogging measures. What is happening here with new masks is that during the manufacturing process a thin film of silicone accumulates on the mask lens. I have seen it countless times a diver with a new mask so fogged you can’t even see his eyes – even after repeated applications of a defog solution! This can be extremely frustrating and even dangerous.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |